Table of Contents
Advertisement
Calibrating mark sensor - overview
Calibrating mark sensor
Calibrating mark sensor - overview
Introduction
Mark sensor calibration may be required when a different developer station or a
different color is used. A message to this effect will be displayed on the operator
panel.
Note:
The 'Calibrate mark sensor' menu is available in both single and twin printing
systems.
However, the menu is not active in the single printing system and in the first printer
of a twin printing system because the mark sensors are automatically calibrated
there.
Manual calibration of the sensors is only required in the second printer.
Prerequisites
Sensor calibration requirements:
The user rights are available for this menu.
The access ticket for this operator panel is requested.
The printing system is in the 'Stop' or 'Operator intervention necessary' status.
No replacement function is being executed.
Overview
You will find information on the following topics:
Calibrating upper mark sensor on page 177
Calibrate lower mark sensor on page 179
176
Chapter 6 Operating the printing system
Advertisement
Table of Contents
