Replacing the fuser roller
Replacing the fuser roller - overview
Caution:
The fuser roller may only be replaced by operators after training or
instructions from Service.
During operation, the components in the fuser station reach a surface
temperature of approximately 230
burns. Do not touch any hot parts behind the safety covers (see
information signs on page
Wear heat protection gloves!
Overview
The following procedure is for replacing the fuser roller:
Preparing to replace the fuser roller and removing the heating element on
page 386
Remove fuser roller on page 390
Install fuser roller on page 393
Installing the heating element and completing replacement of the fuser roller on
page 395
Replacing the fuser roller - overview
o
C. Touching the components can cause
33).
Warning and
385