Table of Contents
Advertisement
Remove fuser roller
Remove fuser roller
Caution:
Observe the safety directives in the section
overview on page
During operation, the components in the fuser station reach a surface
temperature of approximately 230
You could burn yourself if you touch it.
Allow the printing system to cool down for at least 30 minutes.
Put on heat protection gloves to continue working.
Note:
The heating element must be removed before the fuser roller can be removed (see
Preparing to replace the fuser roller and removing the heating element on page
Removing the fuser roller
[213]
Proceed as follows:
1.
Put on heat protection gloves.
[543]
2.
3.
Open the packaging of the new fuser roller at the front end.
390
Chapter 9 Replacing expendables
385.
o
Replacing the fuser roller -
C.
Push in the pressure pin to the
right of the dirt bin and swivel
the dirt bin outwards.
386).
Advertisement
Table of Contents
