Table of Contents
Advertisement
Replacing the pressure roller
Replacing the pressure roller - overview
Caution:
The pressure roller may only be replaced by operators after training or
instructions from service personnel.
The components in the fuser station reach a surface temperature of
approximately 230
touch any parts behind the safety covers (see
on page
33). Wear heat protection gloves when working with fuser station
components.
Overview
Proceed as follows when replacing the pressure roller
Remove pressure roller on page 352
Install pressure roller on page 356
o
C. Touching the components can cause burns. Do not
Replacing the pressure roller - overview
Warning and information signs
351
Advertisement
Table of Contents
