Clean corotrons
Clean corotrons
Note:
Corotrons can only be cleaned when printing is stopped.
To clean the corotrons
[147]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Select the 'Special functions' -> 'Clean corotrons' menu on the operator panel.
3.
Click the 'OK' button to start cleaning the corotrons.
Cleaning of the corotrons begins. The corotrons are driven in and then out
again. The process takes approximately 1 minute.
See
on the operator panel under 'Steps'.
4.
Click the 'OK' button on the operator panel to complete corotron cleaning:
5.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
288
Chapter 7 Cleaning the printing system
Explanation of icons on page 118
for information on the icons displayed