Table of Contents
Advertisement
Preparing to replace the fuser roller and removing the heating element
Preparing to replace the fuser roller and removing the
heating element
Preparing to remove the fuser roller
[211]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Select 'Replace fuser roller' on the operator panel menu under 'VarioStream',
'Changing consumables'.
3.
Click the 'OK' button to start the procedure.
Information on the icons displayed on the operator panel under
'Work-steps': see
Attention:
The heating element must first be removed, before the fuser roller can be
removed.
Removing the heating element
[212]
Proceed as follows:
1.
Open the front and side door of the fuser station.
[531]
Caution
During operation, the components in the fuser station reach a surface tem-
perature of approximately 230
burns.
Do not touch any parts behind the safety covers identified with this icon:
[532]
386
Chapter 9 Replacing expendables
Explanation of icons on page
o
C. Touching the components can cause
118.
Advertisement
Table of Contents
