Table of Contents
Advertisement
Transportation, assembly and installation, repair
Transportation, assembly and installation, repair
Transport
The printing system may only be transported by Service personnel or authorized
transport companies.
Assembly and installation
Observe the following instructions when assembling and installing the printing
system:
The printing system may only be assembled and installed by Service personnel.
The printing system must have a dedicated electrical connection or type B plug
connection (complying with VDE directives, EN 60950).
Do not route the lines and cables in such a way that they can be stepped on or
tripped over.
All printing system accessories and options must comply with statutory
regulations and directives for safety, electromagnetic compatibility,
telecommunications terminal devices as well as with the specifications published
by Océ Printing Systems GmbH.
The installation of other accessories may constitute a violation of these
requirements and directives, and may also damage the printing system.
Consult Service personnel for details on which accessories and options are
permitted for the printing system.
With the exception of optical wave guide connections, all data, signaling,
process, measurement and control lines mapping the printing system with other
devices must be properly grounded.
Data transmission lines should neither be connected nor disconnected during
electrical storms.
Repairs
Repairs to the printing system must only be carried out by Service personnel. Access
to locked areas and areas which can only be opened with special tools is reserved for
Service personnel. Opening the device without authorization and improperly
effected repairs may put operators at considerable risk.
The access ticket used by the Service technician ensures that the printing system
cannot be used via an LAN from a remote operator panel during repair work.
40
Chapter 2 Security
Advertisement
Table of Contents
