Table of Contents
Advertisement
Affixing the paper web
Proceed as follows:
[240]
4.
5.
Cut the paper end of the old paper web at a right angle to the paper web edge
before the external paper feed.
6.
Cut the paper start of the new paper web at a right angle to the paper web
edge.
7.
Affix the paper start of the new paper web to the paper end of the old paper
web. The left paper web edges (as seen in the paper travel direction) must
be aligned exactly.
8.
Click on the 'End' button in the menu 'Configuration' -> 'Printing system' ->
'Paper end functions'.
[241]
9.
206
Chapter 6 Operating the printing system
Only if the paper is wider than
the previously inserted paper:
Set the rear paper web guide at
the lower rerouting rod to paper
width + 1 mm for both printing
systems.
If the new paper is different
a
from the old paper (with or
without guide holes), the pin
wheel (S) must be positioned
S
accordingly in all printing sys-
tems:
H
a: New paper with guide
holes:
Move the lever (H) fully to
the right and release. The
pin wheel is now in the up-
b
per position.
b: New paper without guide
holes:
Move the lever (H) from its
left position fully to the
right and release. The pin
wheel is now in the lower
position.
Advertisement
Table of Contents
