Table of Contents
Advertisement
Remove pressure roller
Remove pressure roller
Caution:
Observe the safety directives in the section
overview on page
To prepare to remove the pressure roller station
[192]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Select the 'VarioStream' 'Changing consumables' 'Replace pressure roller'
menu on the operator panel.
3.
Click the 'OK' button to start the procedure.
Information on the icons displayed on the operator panel under 'Work-steps':
See
4.
Cut inserted paper in the paper input at a right angle to the transport device
and remove from the printing system by continuously pressing the EJECT
button.
To open the doors and flaps and allow the printing system to cool down
[193]
Proceed as follows:
1.
Open the side door of the fuser station.
[467]
2.
352
Chapter 9 Replacing expendables
351.
Explanation of icons on page
Replacing the pressure roller -
118.
Turn the knob of the oiling unit
to the left and swivel up the oil-
ing unit.
Advertisement
Table of Contents
