Preparing to replace the fuser roller and removing the heating element
Proceed as follows:
[536]
6.
[537]
7.
[538]
Caution
During operation, the components in the fuser station and the heating ele-
ment reach a surface temperature of approximately 230
components can cause burns.
8.
Put on heat protection gloves.
[539]
Caution
The heating element glass can be damaged.
Only touch the heating element at the handle and wearing heat protection
gloves and, if necessary, support it at the other end with a gloved hand.
388
Chapter 9 Replacing expendables
Disconnect the heating element
connector plug at the back of
the printing system.
Remove cable from the cable
clamp.
o
C. Touching the