Monitor Functions - Omron SYSDRIVE 3G3MV SERIES User Manual

Communications
Note There is an OR relationship between input from the control terminals and input through commu-
nications. Therefore, if multi-function inputs of this register are set to forward/stop and reverse/
stop, it is possible to execute the RUN command through the multi-function inputs. These settings
are not, however, recommended because these settings establish two command lines.
D Inverter Output (Register 0009 Hex)
Bit No.
0
1
2
3 to 15
Note The settings will be enabled if multi-function outputs 1 through 3 in n057 through n059 are set to
18 for communications output. Then the corresponding output terminal will be turned ON and
OFF through communications.
H Broadcast Message with Slave Address: 00 (00 Hex) Write
Register No.
(Hex)
0000 Not used.
0001 RUN command
0002 Frequency reference
0003 to 000F Not used.
Note 1. Data can be written to registers 0001 and 0002 only.
Note 2. No data can be written to multi-function input.
Note 3. The unit of setting of the broadcast message is different from that in the DSR message to com-
municate with a single Slave.
D RUN Command (Register 0001 Hex)
Bit No.
0
1
2
3
4 to 15

7-6-2 Monitor Functions

Register No.
(Hex)
0020 Status signal
0021 Fault status 1
0022 Data link status
7-22
Multi-function contact output (1: ON)
Multi-function output 1 (1: ON)
Multi-function output 2 (1: ON)
Not used.
Function
RUN command (1: RUN)
Forward/Reverse (1: Reverse)
External fault (1: External fault EF0)
Fault reset (1: Fault reset)
Not used.
Function
Function
Description
---
Refer to the table below.
Set the frequency reference based on the maximum
frequency as 30,000.
---
Function
Description
Refer to the following corresponding table.
Refer to the following corresponding table.
Refer to the following corresponding table.
Chapter 7