Downloading New Software; Software Download Procedure - Gestetner A265 Service Manual

4.2 DOWNLOADING NEW SOFTWARE

4.2.1 SOFTWARE DOWNLOAD PROCEDURE

The software for the scanner controller contains the system software, application
software, and network interface software. The new software can be downloaded
from a flash memory card.
1. Prepare a flash memory card that has been programmed with the latest
software.
2. Turn off the machine and disconnect the Ethernet (STP) cable from the
scanner controller.
3. Remove the cover [A], and insert the flash memory card [B] into the slot so that
the "A" side of the card faces the front of the machine.
4. Turn the machine on and press the Scanner Mode key.
5. Press the INSTALL key in reply to the message. Software download will take
several minutes.
6. Make sure that the machine displays the scanner SP mode, then after new
software has been downloaded successfully, turn off the machine, remove the
card, connect the Ethernet cable, and turn the machine back on.
SM
CÓPIA NÃO CONTROLADA
A844M500.WMF
18-11
CÓPIA NÃO CONTROLADA
DOWNLOADING NEW SOFTWARE
[B]
[A]
A265/A267