Gestetner A265 Service Manual page 622

BIT SWITCHES
System Switch 00
No FUNCTION
5 G3/G4 communication
parameter display
0: Disabled
1: Enabled
6 Protocol dump list output after
each communication
0: Off
1: On
7 Amount of protocol dump data
in one protocol dump list
printout operation
0: Up to the limit of the
memory area for protocol
dumping
1: Last communication only
G3 Communication Parameters
Modem rate
Resolution
Compression
mode
Communication
mode
Width and
reduction
A265/A267
CÓPIA NÃO CONTROLADA
This is a fault-finding aid. The LCD shows the key
parameters (see below). This is normally disabled
because it cancels the CSI display for the user.
Be sure to reset this bit to 0 after testing.
This is only used for communication
troubleshooting. It shows the content of the
transmitted facsimile protocol signals. Always
reset this bit to 0 after finishing testing.
If system switch 09 bit 6 is at "1", the list is only
printed if there was an error during the
communication.
Change this bit to 1 if you want to have a protocol
dump list of the last communication only.
If bit 6 is turned on, the machine prints a protocol
dump list for the last communication only,
regardless of this bit setting.
If system switch 09 bit 6 is at "1", the list is only
printed if there was an error during the
communication.
336: 33600 bps 168: 16800 bps
312: 31200 bps 144: 14400 bps
288: 28800 bps 120: 12000 bps
264: 26400 bps 96: 9600 bps
240: 24000 bps 72: 7200 bps
216: 21600 bps 48: 4800 bps
192: 19200 bps 24: 2400 bps
S: Standard (8 x 3.85 dots/mm)
D: Detail (8 x 7.7 dots/mm)
F: Fine (8 x 15.4 dots/mm)
SF: Superfine (16 x 15.4 dots/mm)
21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
44: Superfine (400 x 400 dpi)
MMR: MMR compression
MR: MR compression
MH: MH compression
JBO: JBIG compression (Optional mode)
JBB: JBIG compression (Basic mode)
ECM: With ECM
NML: With no ECM
A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
CÓPIA NÃO CONTROLADA
COMMENTS
4-18
Rev. 02/2000
SM