Gestetner A265 Service Manual page 652

BIT SWITCHES
Communication Switch 0F
No FUNCTION
0 Not used
to
7
Communication Switch 10
No FUNCTION
0 Memory transmission:
to Maximum number of dialing
7 attempts to the same
destination
Communication Switch 11 - Not used (do not change the settings.)
Communication Switch 12
No FUNCTION
0 Memory transmission: Interval
to between dialing attempts to
7 the same destination
Communication Switch 13 - Not used (do not change the settings.)
Communication Switch 14
No FUNCTION
0 Inch-to-mm conversion during
transmission
0: Disabled 1: Enabled
1-5 Not used
A265/A267
CÓPIA NÃO CONTROLADA
Do not change the settings.
01 - FE (Hex) times
01 - FF (Hex) minutes
0: In immediate transmission, data scanned in
inch format are transmitted without conversion.
In memory transmission, data stored in the SAF
memory in mm format are transmitted without
conversion.
Note: When storing the scanned data into SAF
memory, the fax unit always converts the data
into mm format.
1: The machine converts the scanned data or
stored data in the SAF memory to the format
which was specified in the set-up protocol
(DIS/NSF) before transmission.
Do not change the factory settings.
4-48
CÓPIA NÃO CONTROLADA
COMMENTS
COMMENTS
COMMENTS
COMMENTS
SM