Gestetner A265 Service Manual page 633

System Switch 1E
No FUNCTION
6 Not used
7 RAM initialization after the
optional EXFUNC board is
installed or removed
0: Enabled
1: Disabled
SM
CÓPIA NÃO CONTROLADA
Do not change the settings
When the machine detects that an EXFUNC
board has been installed or removed, the
machine shows the following message on the
display for the customer.
"Adding/Removing FAX Feature Expander causes
data loss. Turn Main Power Switch off and
remove/replace it to avoid loss. To continue,
press Yes."
If Yes is pressed, the machine initializes the RAM
to the "with" or "without card" configuration.
However, changing this bit to "1" disables this
initialization, even if Yes is pressed.
Change this bit to 1 after installing the EXFUNC
board.
0: When the above message is displayed, the
machine initializes the RAM if Yes is pressed. The
amount of data lost depends on whether the
board is in or out. To avoid losing data, the user
must switch off immediately and put the EXFUNC
board back in.
1: When the above message is displayed, the
machine does not initialize the RAM even if Yes is
pressed. However, the fax unit cannot be used
until the user switches off, puts the EXFUNC
board back in, then switches back on. No data is
lost.
4-29
CÓPIA NÃO CONTROLADA
BIT SWITCHES
COMMENTS
A265/A267