Program Upload (Sp5-826) - Gestetner A265 Service Manual

Display during writing
Display when the download is complete
Display if writing failed
NOTE: To see the current firmware version, check SP 7-801-2.

Program Upload (SP5-826)

1. Turn off the main switch.
2. Plug the flash memory card [A] into the card slot (see previous page).
NOTE: Make sure that the surface printed "A" faces the rear side of the
machine (as viewed from the front of the machine).
3. Turn on the main switch.
4. Access SP mode 5-826.
5. The machine erases the current software, then writes the new software to the
flash memory card. This takes about 60 seconds. If uploading failed, an error
message appears. At this time, repeat the upload procedure.
6. Turn off the main switch, then remove the IC card.
SM
CÓPIA NÃO CONTROLADA
[Serviceman P-Mode]
Program Download
Status: 1-02254
Prev.
[Serviceman P-Mode]
Program Download
Completed
Prev.
[Serviceman P-Mode]
Program Download
Loading error!!!
Prev.
4-73
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
1.05 N A 04/1 11:02
Next O K
A265M506.WMF
Sum = 4F2F 1.05 04/1 11:02
Next O K
A265M504.WMF
04/1 11:02
Next O K
A265M505.WMF
A265/A267
Exit
Exit
Exit