Line Type Change - Gestetner A265 Service Manual

LINE TYPE CHANGE

2.5 LINE TYPE CHANGE
When the machine is initially used only with the PSTN, the line type programmed
with phone numbers in Quick Dials and Speed Dials is stored as PSTN G3.
Later, if the line connection is changed so that G3 is to be used only with the ISDN,
the communication port for all stored Quick and Speed Dials must be changed to
ISDN G3.
This feature allows the communication mode and port to be changed for all stored
numbers at once.
Procedure:
1) Change the data in the following RAM addresses.
68E8E4 (H) - Current line type setting.
68E8E5(H) – New line type setting.
NOTE: The default setting for the above addresses are FF(H).
2) Turn the main switch off and on.
Then, the machine checks all phone numbers stored in Quick Dials, Speed
Dials, AI Redial, and Forwarding Stations. If the communication mode and
the port setting for a number is the same as specified for the "current setting"
in the above address, the machine changes these to the "new setting".
3) After this procedure, the data programmed automatically returns to FF(H).
Setting:
These settings can be used only when an optional G3 and/or G4 unit is installed in
the machine.
Bit 0 and 1: Communication mode
Bit 1 0 Setting
0 0 G3
0 1 G4
Other settings - Not used
Bit 2 to 4: Communication port
Bit 4 3 2 Setting
0 0 0 PSTN-1
0 0 1 PSTN-2
0 1 1 ISDN
1 0 0 G3 auto selection (PSTN-1 OR PSTN-2)
Other settings - Not used
Bit 5 to 7: Not used
Allowable settings are as follows:
7
00H 0
04H 0
0DH 0
10H 0
A265/A267
CÓPIA NÃO CONTROLADA
6 5 4
0 0 0
0 0 0
0 0 0
0 0 1
CÓPIA NÃO CONTROLADA
3 2 1
0 0 0
0 1 0
1 1 0
0 0 0
2-24
0 Setting
0 G3-1 (PSTN-1)
0 G3-2 (PSTN-2)
1 G4 (ISDN)
0 G3 (auto selection)
SM