Printer Switches - Gestetner A265 Service Manual

BIT SWITCHES

4.2.3 PRINTER SWITCHES

Printer Switch 00
No FUNCTION
0 Page separation mark
0: Disabled
1: Enabled
1 Repetition of data when the
received page is longer than
the printer paper
0: Disabled
1: Enabled
2 Prints the date and time on
received fax messages
0: Disabled
1: Enabled
3-7 Not used
Printer Switch 01
No FUNCTION
0-2 Not used
3
Maximum print width used in the setup protocol
4
0
=Do not use this setting
0
These bits are only effective when bit 7 of printer switch 01 is "1".
5-6 Not used
7 Received message width
restriction in the protocol
signal to the sender
0: Disabled
1: Enabled
A265/A267
CÓPIA NÃO CONTROLADA
0: No marks are printed.
1: If a received page has to be printed out on two
sheets, an asterisk inside square brackets is
printed at the bottom right hand corner of the first
sheet, and a "2" inside a small box is printed at
the top right hand corner of the second sheet.
This helps the user to identify pages that have
been split.
0: The next page continues from where the
previous page left off.
1: The final few mm of the previous page are
repeated at the top of the next page. The amount
of repeated data depends on printer switch 04,
bits 5 and 6.
See Sub Scan Reduction and Page Separation in
section 2 for details.
This switch is only effective when user parameter
02 - bit 2 (printing the received date and time on
received fax messages) is enabled.
1: The machine prints the received and printed
date and time at the bottom of each received
page.
Do not change the settings.
Do not change the settings.
1 0
=A3
0 1
Do not change the settings.
0: The machine informs the transmitting machine
of the print width depending on the paper size
available from the paper feed stations.
Refer to the table on the next page for how the
machine chooses the paper width used in the
setup protocol (NSF/DIS).
1: The machine informs the transmitting machine
of the fixed paper width which is specified by bits
3 and 4 above.
4-36
CÓPIA NÃO CONTROLADA
COMMENTS
COMMENTS
1
=B4 =A 4
1
SM