Gestetner A265 Service Manual page 648

BIT SWITCHES
Communication Switch 06
No FUNCTION
0 Dialing requirements:
Germany
0: Disabled 1: Enabled
1 Dialing requirements: Austria
0: Disabled 1: Enabled
2 Dialing requirements: Norway
0: Disabled 1: Enabled
3 Dialing requirements:
Denmark
0: Disabled 1: Enabled
4 Dialing requirements: France
0: Disabled 1: Enabled
5 Dialing requirements:
Switzerland
0: Disabled 1: Enabled
6
Not used
7
Carrier drop display
0: Disabled 1: Enabled
Communication Switch 07
No FUNCTION
0
Fallback from G4 to G3 if the
other terminal is not a G4
terminal
0: Disabled
1: Enabled
1
Not used
2
Not used
3 Fallback from G4 to G3
reflected in programmed
Quick/Speed dials
0: Fallback enabled
1: Always start with G4
4
Fallback from G4 to G3 when
G4 communication fails on the
ISDN B-channel
0: Fallback disabled
1: Fallback enabled
5
Not used
6
Not used
7 Not used
A265/A267
CÓPIA NÃO CONTROLADA
These switches are automatically set to the
settings required by each country after the
country code (System Switch 0F) is programmed.
Do not change the setting.
This is an European PTT requirement.
This bit is available only for the European models.
Also see system switch 0A bit 7.
Refer to the ISDN G4 option service manual (G4
Internal Switches 17, 18, 1A, 1B, and 1C) for the
CPS code set (Cause Value set) that determines
G4 to G3 fallback.
Do not change the setting.
Do not change the setting.
0: If a communication falls back from G4 to G3,
the machine will always start transmission with
G3 from the next communication.
1: The machine will always start to transmit with
G4.
1: Enable this switch only when G4
communication errors occur because the
exchanger connects G4 calls to the PSTN.
This problem occurs with some types of
exchanger.
Do not change the setting.
Do not change the setting.
Do not change the setting.
4-44
CÓPIA NÃO CONTROLADA
COMMENTS
COMMENTS
SM