Gestetner A265 Service Manual page 827

Rev. 12/2000
B306 PRINTER OPTION FIRMWARE MODIFICATION HISTORY
DESCRIPTION OF MODIFICATION
⇒
•
Part of the image is missing for the first
two pages when printing out with the
Unico2000 CAD application.
•
When printing out with the Microsoft Mini
Driver for Windows NT Terminal Server,
the image created is sometimes out of
specification.
•
When printing out a file made with certain
CAD applications for DOS without using a
printer driver, thick lines on the original
image appear thin on the output.
** To activate this correction, it is
necessary to set Bit SW3, bit 3 to 1
(0=disabled, 1=Enabled).
•
Firmware modified to meet the functional
specifications of the Tray Priority function.
•
Some stapling modes, the printing image
direction is not same as copier's.
** To activate this correction, it is
necessary to set Bit SW3, bit 7 to 1
(0=disabled, 1=Enabled).
•
The print speed slows down during
continuos printing of a 1-page job.
** To activate this correction, it is
necessary to set Bit SW3, bit 2 to 1
(0=Disabled, 1=Enabled) and set Bit SW3,
bit 4 to 1 (DAZEL* support function
disabled). The correction will not be
effective if both of these switches are
enabled.
•
Firmware modified so that the controller
can connect to and be used with the
DAZEL System. However, the A265/A267
is not yet officially certified by DAZEL
Corp. When you enable this function, it is
necessary to do the following:
-Upgrade the NIB firmware to version
4.0.6 or later and the PS3 firmware to
version 1.2.4 or later.
-Set NIC to bi-directional-mode (refer to
NIC manual).
-Do not set Bit SW3, bit 2 to 1 (as
explained above, these two SW should
not be simultaneously enabled).
* To deactivate the DAZEL support
function, set Bit SW3, bit 4 to 1
(0=Enabled, 1=Disabled).
SM
CÓPIA NÃO CONTROLADA
FIRMWARE
LEVEL
B3065280 F
6-7
CÓPIA NÃO CONTROLADA
FIRMWARE HISTORY
SERIAL FIRMWARE
NUMBER VERSION
Nov. 2000 1.4.4
Production
A265/A267