Gestetner A265 Service Manual page 523

SCANNER FUNCTIONS
9. Turn the machine on, SC4003 may occur. Do the following procedure to clear
the SC condition.
NOTE: The meaning of SC4003 is that the battery worn out. Even if the TB4 is
shorted by the jumper chip, the battery level is low at the time of
installation of the scanner controller board. This SC condition will not
occur for about 30 minutes after the TB4 has been shorted.
1) Enter SP mode (
than 3 seconds).
2) Select 4 (Scanner SP mode).
3) Press the Next bottom 4 times to access SP005 (Error Log Indication).
4) Leave the SP mode.
5) Turn the machine off and on. If SC4003 still occur, check the jumper
position.
10. Make sure that the parallel cable is not connected to the printer controller and
check the setting of the following copier SP mode (enter the SP mode and
select 1):
• SP5-907: Plug & Play Brand Name and Production Name Setting – select
the correct one.
11. Attach the core [A] to the STP (Shielded Twist Pair) cable, then connect the
cable to the scanner controller.
A265/A267
CÓPIA NÃO CONTROLADA
"#→#$#→#%#→#&#→#'#
18-8
CÓPIA NÃO CONTROLADA
[A]
A844R502.WMF
'
press for more
SM