Gestetner A265 Service Manual page 623

Rev. 02/2000
I/O rate 0: 0 ms/line
25: 2.5 ms/line
5: 5 ms/line
Note:
"40" is displayed while receiving a fax message using AI short
protocol.
G4 Communication Parameters
Compression MMR: MMR compression
MR: MR compression
mode
MH: MH compression
Resolution 21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
44: Superfine (400 x 400 dpi)
Width and A4: A4 (8.3"), no reduction
reduction B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
Transfer T: Transfer
- : Other
Confidential C: Confidential
- : Other
Other parameters
The following information is shown in 6-bit format. Bit 1 is the first
bit from the left, and bit 6 is at the right end.
Bit 1 - Smoothing
(Smoothing is disabled in halftone mode.)
Bit 2 - CIL printing
Bit 3 - Not used
Bit 4 - mm/inch conversion 0: Off, 1: On
Bit 5 - Engine type
Bit 6 - Document resolution unit 0: mm, 1: inches
System Switch 01
No FUNCTION
0 Automatic Service Call at PM
0: Disabled
1: Enabled
1-7 Not used
SM
CÓPIA NÃO CONTROLADA
10: 10 ms/line
20: 20 ms/line
40: 40 ms/line
0: Off, 1: On
0: On, 1: Off
0: mm, 1: inches
This bit switch determines whether the machine
will send an Auto Service Call to the service
station when it is time for PM.
Cross reference
Auto service calls: Section 2.1
Do not change the settings.
4-19
CÓPIA NÃO CONTROLADA
BIT SWITCHES
COMMENTS
A265/A267