Gestetner A265 Service Manual page 820

NIB
5.3 NIB
NOTE: 1) Before replacing the NIB, back up the NIB NVRAM to the controller
using the "NIB read/write" service tool. Then, replace the NIB. Then
restore the NIB NVRAM using the "NIB read/write" service tool. Refer to
section 4.4.3 for details.
2) If the NIB does not start up after a firmware update using the NBTFTP
utility, try downloading the firmware from an IC card.
1. Back up the NIB NVRAM to the controller using [Service Tool] – [NIB
read/write].
2. Remove the printer controller (See Controller Removal).
3. Replace the NIB (2 screws).
4. Put back the controller.
5. Turn on the machine and restore the NIB NVRAM using the [Service Tool] –
[NIB read/write].
6. Turn off the machine and turn it back on. Then, print the Printer Configuration
Page ([User Tools] – [Printer] – [List Print]).
Ensure that all the controller settings are restored.
A265/A267
CÓPIA NÃO CONTROLADA
5-2
CÓPIA NÃO CONTROLADA
SM