Gestetner A265 Service Manual page 624

BIT SWITCHES
System Switch 02
No FUNCTION
0-3 Not used
4 File retention time
0: Depends on User
Parameter 24 [18(H)]
1: No limit
5 Not used
6 Memory read/write by RDS
7 Bit 7 6
0 0
0 1
1 0
1 1
System Switch 03
No FUNCTION
0 Length of time that RDS is
to temporarily switched on when
7 bits 6 and 7 of System Switch
02 are set to "User selectable"
System Switch 04
No FUNCTION
0-2 Not used
3 Printing dedicated tx
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
4 Not used
A265/A267
CÓPIA NÃO CONTROLADA
Do not change the settings.
1: A file that had a communication error will not
be erased unless the communication is
successful.
Do not change the settings.
(0,0): All RDS systems are always locked out.
Setting (0,1), (1,0): Normally, RDS systems are locked
Always disabled out, but the user can temporarily switch RDS on
User selectable to allow RDS operations to take place. RDS will
User selectable automatically be locked out again after a certain
Always enabled time, which is stored in System Switch 03. Note
that if an RDS operation takes place, RDS will not
switch off until this time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System
Switch 02 are set to "User selectable".
The default setting is 24 hours.
Do not change the settings.
1: Each Quick/Speed dial number on the list is
printed with the dedicated tx parameters (8 bytes
each).
The last 10 bytes of data are the programmed
dedicated tx parameters; 32 bytes of data are
printed (the other 22 bytes have no use for
service technicians).
Do not change the settings.
CÓPIA NÃO CONTROLADA
COMMENTS
COMMENTS
COMMENTS
4-20 SM