Rev. 09/2000
4.4.2 HDD FORMAT
This creates partitions on the HDD and formats them.
1. Enter the Printer SP mode, and select "2. Service Tool".
2. Select "HDD Format", then press [Enter].
3. Check the HDD capacity, then press [Enter].
4. Press [Enter] again to start formatting. Or, press [Cancel] to exit.
NOTE: Once the format has started, it cannot be cancelled.
5. Check the result of the test, then do the following:
• If the result is OK, press [Enter] to exit.
• If the result is NG, check the error message, then press [Enter] to exit.
Error Display Details
Error Messages
⇒
SM
CÓPIA NÃO CONTROLADA
"HDD Ident Fail"
The controller could not retrieve information from the HDD.
"NG Logic Format"
Logical format failed.
"No Support HDD"
Unsupported HDD is detected.
4-7
CÓPIA NÃO CONTROLADA
SERVICE TABLES
A265/A267