Gestetner A265 Service Manual page 625

System Switch 04
No FUNCTION
5 Memory file transfer operation
0: User level
1: Service level
6
G3 CSI/G4 Terminal ID
programming level
0: User level
1: Service level
7 Telephone line type
programming mode
0: User level
1: Service level
System Switch 05
No FUNCTION
0-1 Not used
2 Display of both RTI and CSI
on the LCD
0: Disabled
1: Enabled
3-7 Not used
System Switch 06
No FUNCTION
0 Margin setting for Create
to
Margin Transmission
7
SM
CÓPIA NÃO CONTROLADA
If the machine is unable to print fax messages
due to a mechanical problem, change this bit to 0
to transfer all messages in the memory (including
confidential rx messages) to an another terminal.
Always reset this bit to 1 after transfer. However,
this bit can be left at 0, if the customer's key-
operators want to transfer the files themselves.
Procedure
1. Enter service mode and change this bit to 0.
2. Exit the service mode.
3. Enter the user tools, and select "Key-
operator settings".
4. Choose "03" and specify a destination for the
machine to transfer all the files to.
5. Press "Start".
6. After the machine transfers the memory files,
enter the service mode and reset this bit to 1.
Otherwise, anybody who knows how to enter
the key-operator mode can transfer
confidential messages.
1: The CSI and Terminal ID can only be
programmed by a technician (in the user tools).
The Terminal ID can only be programmed if a
Group 4 option is installed.
1: Telephone line type selection (choosing tone
dial or pulse dial) can only be programmed by a
technician (in the user tools).
Do not change the settings.
1: An RTI will be displayed until phase B of the
protocol sequence, and a CSI will be displayed
after phase C.
Do not change the settings.
71 to 99 (BCD) %. This setting determines the
reduction ratio when the user uses the Create
Margin Transmission feature.
Default setting:1001 0011 (93%)
4-21
CÓPIA NÃO CONTROLADA
BIT SWITCHES
COMMENTS
COMMENTS
COMMENTS
A265/A267