Removing A Flex Ioc; Installing A Flex Ioc; Removing A Port Module; Installing A Port Module - Juniper SRX 5600 Hardware Manual

replacing a flex IOC or port module, review the information in "Handling and Storing
Cards" on page 86. To replace a flex IOC or port module, use the following procedures:

Removing a Flex IOC

A flex IOC weighs up to 13.1 lb (5.9 kg). Be prepared to accept the full weight of the
card as you remove it.
To remove a flex IOC (see Figure 57 on page 122):
1.
2.
3.
4.
5.
6.
7.
Removing a Flex IOC on page 121
Installing a Flex IOC on page 123
Removing a Port Module on page 124
Installing a Port Module on page 126
Have ready a replacement card or blank panel and an antistatic mat for the flex
IOC.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 152.
Use one of the following methods to take the flex IOC offline:
Press and hold the corresponding online button on the craft interface. The
green LED next to the button begins to blink. Hold the button down until
OK
the LED goes off.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number offline
For more information about the command, see the JUNOS System Basics and
Services Command Reference.
If you have not already done so, remove the port modules installed in the flex
IOC as described in "Removing a Port Module" on page 124.
Simultaneously turn both of the ejector handles counterclockwise to unseat the
flex IOC.
Grasp the handles and slide the flex IOC straight out of the card cage halfway.
Place one hand around the front of the flex IOC and the other hand under it to
support it. Slide the flex IOC completely out of the chassis, and place it on the
antistatic mat or in the electrostatic bag.
Chapter 13: Replacing Hardware Components
Replacing Flex IOCs and Port Modules
121