Installing A Routing Engine - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide

Installing a Routing Engine

To install a Routing Engine into an SCB (see Figure 51 on page 115):
1.
2.
3.
4.
5.
6.
7.
8.
The Routing Engine might require several minutes to boot.
After the Routing Engine boots, verify that it is installed correctly by checking the
RE0
the Routing Engine is functioning properly, the green
the red
(see "Removing a Routing Engine" on page 113 and "Installing a Routing Engine" on
page 114). If the red
properly. Contact your customer support representative.
To check the status of the Routing Engine, use the CLI command:
user@host> show chassis routing-engine
Routing Engine status:
For more information about using the CLI, see the JUNOS software manuals.
114
Replacing Host Subsystem Components
If you have not already done so, power off the device. See "Powering Off the
Services Gateway" on page 70.
Ensure that the ejector handles are not in the locked position. If necessary, flip
the ejector handles outward.
Place one hand underneath the Routing Engine to support it.
Carefully align the sides of the Routing Engine with the guides inside the opening
on the SCB.
Slide the Routing Engine into the SCB until you feel resistance, and then press
the Routing Engine's faceplate until it engages the connectors.
Press both of the ejector handles inward to seat the Routing Engine.
Tighten the captive screws on the left and right of the Routing Engine.
Power on the services gateway as described in "Powering On an AC-Powered
Services Gateway" on page 65 or "Powering On a DC-Powered Services Gateway"
on page 68. The OK LED on the power supply faceplate should blink, then light
steadily.
and RE1 LEDs on the craft interface. If the services gateway is operational and
FAIL LED lights steadily instead, remove and install the Routing Engine again
LED still lights steadily, the Routing Engine is not functioning
FAIL
Slot 0:
LED lights steadily. If
ONLINE
Current state Master ...