SRX 5600 Services Gateway Hardware Guide
Table 9: 16-Port TX Ethernet Port Module LEDs
Services Processing Cards
Services Processing Cards (SPCs) provide the processing power to run integrated
services such as firewall, IPsec, and IDP (see Figure 9 on page 15). All traffic traversing
the services gateway is passed to an SPC to have services processing applied to it.
Traffic is intelligently distributed by IOCs to SPCs for service processing. Each SPC
comprises two or more Services Processing Units (SPUs).
The services gateway must have at least one SPC installed. You can install additional
SPCs to increase services processing throughput.
The services gateway has a total of 8 slots. You can install SPCs in any of the slots
numbered
numbered
SPCs install horizontally in the front of the device (see Figure 10 on page 15).
If a slot is not occupied by a card, a blank panel must be installed to shield the empty
slot and to allow cooling air to circulate properly through the device.
Figure 9 on page 15 shows a typical SPC supported on the SRX 5600 services
gateways.
14
Services Processing Cards
Label
Color
State
Green
On steadily
OK/FAIL
Red
On steadily
Link (top or
Green
On steadily
left of each
port)
Off
TX/RX
Green
Blinking
(bottom or
right of
Off
each port)
through
, top to bottom. The slots at the bottom of the card cage
0
5
0
and
1
are reserved for SCBs.
Description
Port module is functioning normally.
Port module has failed.
Link is active.
No link.
Port is receiving or transmitting data.
No activity.