Removing An Air Filter; Installing The Air Filter; Figure 45: Installing The Fan Tray - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide

Figure 45: Installing the Fan Tray

Replacing the Air Filter
The services gateway has one air filter that installs vertically in the rear of the chassis.
The air filter is hot-insertable and hot-removable.
The air filter is located in the rear of the chassis on the left side. The air filter weighs
approximately 1 lb (0.5 kg).
To replace an air filter, use the following procedures:

Removing an Air Filter

CAUTION: Do not run the services gateway for more than a few minutes without the
air filter in place.
CAUTION: Always keep the air filter in place while the device is operating, except
during replacement. Because the fans are very powerful, they could pull small bits
of wire or other materials into the device through the unfiltered air intake. This could
damage the services gateway components.
106
Replacing Cooling System Components
Removing an Air Filter on page 106
Installing the Air Filter on page 107