Troubleshooting The Power System - Juniper SRX 5600 Hardware Manual

Troubleshooting the Power System

To verify that a power supply is functioning normally, perform the following steps:
4 Empty
5 Online
57
For more detailed output, add the
specify a slot number, which is optional:
user@host> show chassis fpc detail
Slot 0 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
Slot 1 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
Slot 2 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
Slot 5 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
For further description of the output from the commands, see the JUNOS System
Basics and Services Command Reference.
Check the LEDs on each power supply faceplate. If an AC power supply is
correctly installed and functioning normally, the
steadily, and the PS FAIL LED is not lit. If a DC power supply is correctly installed
Chapter 12: Troubleshooting Hardware Components
42 6 0
option. The following example does not
detail
Online
41 degrees C / 105 degrees F
1024 MB
256 MB
4096 MB
2007-07-10 12:28:33 PDT
1 hour, 33 minutes, 52 seconds
Online
43 degrees C / 109 degrees F
1024 MB
256 MB
4096 MB
2007-07-10 12:28:38 PDT
1 hour, 33 minutes, 47 seconds
Online
43 degrees C / 109 degrees F
1024 MB
256 MB
4096 MB
2007-07-10 12:28:40 PDT
1 hour, 33 minutes, 45 seconds
Online
42 degrees C / 107 degrees F
1024 MB
256 MB
4096 MB
2007-07-10 12:28:42 PDT
1 hour, 33 minutes, 43 seconds
AC OK
Troubleshooting the Power System
1024 16
and LEDs light
DC OK
97