Troubleshooting Spcs - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide

Troubleshooting SPCs

This chapter discusses how to troubleshoot the SPCs in the device:
To troubleshoot the SPC, follow these guidelines:
96
Troubleshooting SPCs
Start time:
Uptime:
Slot 1 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
Slot 2 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
Slot 5 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
For further description of the output from the commands, see the JUNOS System
Basics and Services Command Reference.
Make sure the SPC is properly seated in the midplane. Check that each ejector
handle has been turned clockwise and is tight.
Issue the CLI
show chassis fpc
As shown in the sample output, the value
indicates that the SPC is functioning normally:
user@host> show chassis fpc
Temp CPU Utilization (%)
Slot State
0 Online
57
1 Online
57
2 Online
57
3 Empty
2007-07-10 12:28:33 PDT
1 hour, 33 minutes, 52 seconds
Online
43 degrees C / 109 degrees F
1024 MB
256 MB
4096 MB
2007-07-10 12:28:38 PDT
1 hour, 33 minutes, 47 seconds
Online
43 degrees C / 109 degrees F
1024 MB
256 MB
4096 MB
2007-07-10 12:28:40 PDT
1 hour, 33 minutes, 45 seconds
Online
42 degrees C / 107 degrees F
1024 MB
256 MB
4096 MB
2007-07-10 12:28:42 PDT
1 hour, 33 minutes, 43 seconds
command to check the status of installed SPCs.
Online in the column labeled
Memory
(C) Total Interrupt
41 9 0
43 5 0
43 11 0
State
Utilization (%)
DRAM (MB) Heap Buffer
1024 15
1024 16
1024 16