Appendix F; Installing The Services Gateway Without A Mechanical Lift; Tools And Parts Required - Juniper SRX 5600 Hardware Manual

Appendix F

Installing the Services Gateway Without
a Mechanical Lift

Tools and Parts Required

Removing Components from the Chassis
If you cannot use a mechanical lift to install the services gateway (the preferred
method), you can install it manually. Before installing the device manually, you must
first remove components from the chassis, and you must reinstall the components
once the device is installed in the rack. At least two people are needed to safely lift
the chassis into the rack or cabinet. With components removed, the chassis weighs
approximately 65.5 lb (29.7 kg).
Before installing the device in the rack, read the safety information in "Chassis Lifting
Guidelines" on page 154. Remove the device from the shipping container as described
in "Unpacking the Services Gateway" on page 45. Install the mounting hardware as
described in "Installing the Mounting Hardware" on page 49.
This appendix discusses the following device installation topics:
Tools and Parts Required on page 201
Removing Components from the Chassis on page 201
Installing the Chassis in the Rack Manually on page 206
Reinstalling Components in the Chassis on page 208
Installing the Cable Management System on page 212
To install the device, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
3/8-in. nut driver
ESD grounding wrist strap
To make the services gateway light enough to install manually, you first remove most
components from the chassis. The procedures in this section for removing
components from the chassis are for initial installation only, and assume that you
have not connected power cables to the services gateway. The following procedures
Tools and Parts Required
201