Figure 66: Installing An Ac Power Supply - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide
Installing an AC Power Supply
To install an AC power supply (see Figure 66 on page 136):
1.
2.
3.
4.
5.
6.
7.
8.

Figure 66: Installing an AC Power Supply

136
Replacing Power System Components
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 152.
Move the AC switch next to the appliance inlet on the power supply to the off
position ( ).
O
Using both hands, slide the power supply straight into the chassis until the power
supply is fully seated in the chassis slot. The power supply faceplate should be
flush with any adjacent power supply faceplate (see Figure 82 on page 209).
Tighten both captive screws at the bottom of the power supply.
Attach the power cord to the power supply.
Route the power cord along the cable restraint towards the left or right corner
of the chassis. If needed to hold the power cord in place, thread plastic cable
ties, which you must provide, through the openings on the cable restraint.
Attach the power cord to the AC power source, and switch on the dedicated
facility circuit breaker for the power supply. Follow the ESD and connection
instructions for your site.
Move the AC switch next to the appliance inlet on the power supply to the on
position ( | ) and observe the status LEDs on the power supply faceplate. If the
power supply is correctly installed and functioning normally, the
DC OK LEDs light steadily, and the PS FAIL LED is not lit.
and
AC OK