Maintaining Ioc Cables - Juniper SRX 5600 Hardware Manual

Maintaining IOC Cables

To maintain IOC cables, follow these guidelines:
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
Slot 5 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
Issue the CLI
show chassis fpc pic-status
through 5 , left to right:
user@host> show chassis fpc pic-status
Slot 0 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
Slot 1 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
Slot 2 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
Slot 3 Online
PIC 0 Offline
PIC 1 Offline
Slot 4 Online
PIC 0 Offline
PIC 1 Offline
For further description of the output from the command, see the JUNOS System
Basics and Services Command Reference.
Use the cable management system (shown in Figure 14 on page 23) to support
cables and prevent cables from dislodging or developing stress points.
Place excess cable out of the way in the cable management system. Do not allow
fastened loops of cable to dangle from the connector or cable management
Chapter 11: Maintaining Hardware Components
256 MB
4096 MB
2007-07-10 12:28:40 PDT
1 hour, 33 minutes, 45 seconds
Online
42 degrees C / 107 degrees F
1024 MB
256 MB
4096 MB
2007-07-10 12:28:42 PDT
1 hour, 33 minutes, 43 seconds
command. The slots are numbered
SRX5k DPC 40x 1GE
10x 1GE RichQ
10x 1GE RichQ
10x 1GE RichQ
10x 1GE RichQ
SRX5k DPC 40x 1GE
10x 1GE RichQ
10x 1GE RichQ
10x 1GE RichQ
10x 1GE RichQ
SRX5k DPC 40x 1GE
10x 1GE RichQ
10x 1GE RichQ
10x 1GE RichQ
10x 1GE RichQ
SRX5k SPC
SRX5k SPC

Maintaining IOC Cables

0
85