Removing The Fan Tray; Removing Scbs; Figure 78: Removing The Fan Tray - Juniper SRX 5600 Hardware Manual

Removing the Fan Tray

In the rear of the chassis, the fan tray is located on the right of the chassis. The fan
tray weighs about 6.8 lb (3.08 kg).
To remove the fan tray (see Figure 78 on page 203 ):
1.
2.
3.
4.

Figure 78: Removing the Fan Tray

Removing SCBs

The device can have two SCBs. They are located horizontally on the bottom front of
the chassis in the slots marked
9.6 lb (4.4 kg).
Appendix F: Installing the Services Gateway Without a Mechanical Lift
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 152.
Loosen the captive screw on each side of the fan tray faceplate.
Grasp both sides of the fan tray and pull it out approximately 1 to 3 inches.
Place one hand under the fan tray to support it and pull the fan tray completely
out of the chassis.
0 and 1 . Each SCB weighs approximately
Removing Components from the Chassis
203