Figure 27: Installing The Mounting Hardware For An Open-Frame Rack - Juniper SRX 5600 Hardware Manual

Figure 27: Installing the Mounting Hardware for an Open-Frame Rack

Removing the Mounting Brackets for Center-Mounting the Device
Two removable mounting brackets are attached to the mounting holes closest to the
front of the chassis. You can move the pair of brackets to another position on the
side of the chassis for center-mounting the device.
To move the mounting brackets from the front of the chassis toward the center of
the chassis, follow this procedure for each bracket:
1.
2.
3.
4.
5.
6.
Remove the three screws at the top and center of the bracket.
Pull the top of the the bracket slightly away from the chassis. The bottom of the
bracket contains a tab that inserts into a slot in the chassis.
Pull the bracket away from the chassis so that the tab is removed from the chassis
slot.
Insert the bracket tab into the slot in the bottom center of the chassis.
Align the bracket with the two mounting holes located toward the top center of
the chassis.
There is no mounting hole in the center of the chassis that corresponds to the
hole in the center of the bracket.
Insert the two screws at the top of the bracket and tighten each partially.
Removing the Mounting Brackets for Center-Mounting the Device
Chapter 6: Installing the Mounting Hardware
51