Appendix H Cable Connector Pinouts; Rj-45 Connector Pinouts For The Routing Engine Ethernet Port; Rj-45 Connector Pinouts For The Routing Engine Aux And Console Ports; Table 42: Rj-45 Connector Pinout For The Routing Engine Ethernet - Juniper SRX 5600 Hardware Manual

Appendix H
Cable Connector Pinouts

RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port

RJ-45 Connector Pinouts for the Routing Engine AUX and CONSOLE Ports

This appendix describes the pinouts for the following cable connectors:
RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port on page 225
RJ-45 Connector Pinouts for the Routing Engine AUX and CONSOLE
Ports on page 225
The port on the craft interface labeled ETHERNET is an autosensing 10/100-Mbps
Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing
Engine to a management LAN (or other device that supports out-of-band
management). For more information, see "Routing Engine Interface Ports and Status
Indicators" on page 21. Table 42 on page 225 describes the RJ-45 connector pinout.
Table 42: RJ-45 Connector Pinout for the Routing Engine ETHERNET Port
Pin Signal
1 TX+
2 TX–
3 RX+
4 Termination network
5 Termination network
6 RX–
7 Termination network
8 Termination network
The ports on the craft interface labeled AUX and CONSOLE are RJ–232 serial interfaces
that accept an RJ-45/DB-9 cable for connecting the Routing Engine to an auxiliary or
RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port
225