Figure 46: Removing The Air Filter - Juniper SRX 5600 Hardware Manual

To remove the air filter (see Figure 46 on page 107):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
1.
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 152.
Loosen the captive screws on the air filter cover.
2.
Remove the air filter cover.
3.
Slide the air filter out of the chassis.
4.

Figure 46: Removing the Air Filter

Installing the Air Filter
To install the air filter (see Figure 47 on page 108):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
1.
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 152.
Locate the up arrow and ensure that the air filter is right side up.
2.
Slide the air filter straight into the chassis until it stops.
3.
Align the captive screws of the air filter cover with the mounting holes on the
4.
chassis.
Tighten the captive screws on the air filter cover.
5.
Chapter 13: Replacing Hardware Components
Replacing Cooling System Components
107