Reinstalling Components In The Chassis; Reinstalling The Power Supplies; Reinstalling The Fan Tray; Figure 81: Installing The Services Gateway Chassis In The Rack - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide

Figure 81: Installing the Services Gateway Chassis in the Rack

NOTE: This illustration depicts the services gateway being installed in an open-frame
rack. For an illustration of the mounting hardware required for a four-post rack or
cabinet, see Figure 26 on page 50.

Reinstalling Components in the Chassis

After the services gateway chassis is installed in the rack, you reinstall the removed
components before booting and configuring it. The following procedures describe
how to reinstall components in the chassis, first in the rear and then in the front:
208
Reinstalling Components in the Chassis
Reinstalling the Power Supplies on page 209
Reinstalling the Fan Tray on page 209
Reinstalling SCBs on page 210
Reinstalling IOCs and SPCs on page 211