Flex I/O Cards And Port Modules; Flex I/O Cards And Port Modules Specifications; Flex I/O Card (Srx5K-Fpc-Ioc) Specifications - Juniper SRX5400 Manual

CHAPTER 4

Flex I/O Cards and Port Modules

IN THIS CHAPTER

Flex I/O Cards and Port Modules Specifications | 29

Flex I/O Cards and Port Modules Specifications
IN THIS SECTION

Flex I/O Card (SRX5K-FPC-IOC) Specifications | 29

Flex I/O Card Port Module SRX-IOC-16GE-SFP Specifications | 31
Flex I/O Card Port Module SRX-IOC-16GE-TX Specifications | 33
Flex I/O Card Port Module SRX-IOC-4XGE-XFP Specifications | 34
Flex I/O Card (SRX5K-FPC-IOC) Specifications
The SRX5K-FPC-IOC Flex I/O card (Flex IOC)
port modules that add Ethernet ports to your services gateway. A Flex IOC with installed port modules
functions in the same way as a regular IOC, but allows greater flexibility in adding different types of Ethernet
ports to your services gateway.
Each Flex IOC has a processor subsystem, which includes a 1.2-GHz CPU, a system controller, 1 GB
SDRAM, and two Packet Forwarding Engines with a maximum throughput of 10 Gbps each.
You must install at least one IOC in the services gateway. The IOC can be of any of the available IOC or
Flex IOC types.
You can install Flex IOCs in any of the slots that are not reserved for Switch Control Boards (SCBs). If a
slot is not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling
air to circulate properly through the services gateway.
(Figure 11 on page 30) is an IOC with two slots that accept
29