Qualified Personnel Warning; Restricted Access Area Warning; Preventing Electrostatic Discharge Damage; General Safety Guidelines And Warnings - Juniper SRX 5600 Hardware Manual

General Safety Guidelines and Warnings

The following guidelines help ensure your safety and protect the services gateway
from damage. The list of guidelines might not address all potentially hazardous
situations in your working environment, so be alert and exercise good judgment at
all times.
In addition, observe the following warnings and guidelines:
Maintenance and Operational Safety Guidelines and Warnings on page 162
Electrical Safety Guidelines and Warnings on page 167
Perform only the procedures explicitly described in this manual. Make sure that
only authorized service personnel perform other system services.
Keep the area around the chassis clear and free from dust before, during, and
after installation.
Keep tools away from areas where people could trip over them while walking.
Do not wear loose clothing or jewelry, such as rings, bracelets, or chains, which
could become caught in the chassis.
Wear safety glasses if you are working under any conditions that could be
hazardous to your eyes.
Do not perform any actions that create a potential hazard to people or make the
equipment unsafe.
Never attempt to lift an object that is too heavy for one person to handle.
Never install or manipulate wiring during electrical storms.
Never install electrical jacks in wet locations unless the jacks are specifically
designed for wet environments.
Operate the services gateway only when it is properly grounded.
Do not open or remove chassis covers or sheet metal parts unless instructions
are provided in this manual. Such an action could cause severe electrical shock.
Do not push or force any objects through any opening in the chassis frame. Such
an action could result in electrical shock or fire.
Avoid spilling liquid onto the services gateway chassis or onto any services
gateway component. Such an action could cause electrical shock or damage the
services gateway.
Avoid touching uninsulated electrical wires or terminals that have not been
disconnected from their power source. Such an action could cause electrical
shock.
Qualified Personnel Warning on page 150
Restricted Access Area Warning on page 150
Preventing Electrostatic Discharge Damage on page 152
Appendix A: Safety and Regulatory Compliance Information
Safety Guidelines and Warnings
149