Unpacking The Services Gateway; Tools And Parts Required; Verifying Parts Received - Juniper SRX 5600 Hardware Manual

Chapter 5

Unpacking the Services Gateway

Tools and Parts Required

After you have prepared your installation site as described in "Preparing the Site for
Services Gateway Installation" on page 37, you are ready to unpack and install the
services gateway. It is important to proceed through the installation process in the
following order:
Review the safety guidelines explained in "Safety and Regulatory Compliance
1.
Information" on page 147.
Follow the instructions in this chapter to unpack the services gateway and verify
2.
the parts received.
Install the mounting hardware as described in "Installing the Mounting Hardware"
3.
on page 49.
Install the services gateway as described in "Installing the Services Gateway" on
4.
page 53 or "Installing the Services Gateway Without a Mechanical Lift" on page
201.
Perform the initial system startup as described in "Connecting the Services
5.
Gateway" on page 57.
This chapter describes how to prepare to install the services gateway. It discusses
the following topics:
Tools and Parts Required on page 45
Unpacking the Services Gateway on page 46
Verifying Parts Received on page 47
To unpack the services gateway and prepare for installation, you need the following
tools:
Phillips (+) screwdriver, number 2
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the
shipping pallet
Blank panels to cover any slots not occupied by a component
Tools and Parts Required
45