Replacing Iocs; Removing An Ioc; Installing An Ioc; Figure 53: Cable Connectors - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide
3.
4.

Figure 53: Cable Connectors

Replacing the Console or Auxiliary Cable
To use a system console to configure and manage the Routing Engine, connect it to
the
device, connect it to the
with an RJ-45 connector. One RJ-45/DB-9 cable is provided with the device. If you
want to connect a device to both ports, you must supply another cable. For cable
specifications, see "Routing Engine Interface Cable and Wire Specifications" on page
200.
To connect a management console or auxiliary device:
1.
2.
3.
4.
5.

Replacing IOCs

IOCs are installed horizontally in the front of the services gateway. The IOCs are
hot-insertable and hot-removable. When you remove an IOC, the services gateway
continues to function, although the IOC being removed no longer functions. Before
replacing anIOC, review the information in "Holding a Card" on page 87. To replace
an IOC, use the following procedures:

Removing an IOC

An IOC weighs up to 13.1 lb (5.9 kg). Be prepared to accept its full weight.
116

Replacing IOCs

Plug one end of the replacement cable into the
page 115 shows the external device ports on the Routing Engine.
Plug the other end of the cable into the network device.
CONSOLE port on the Routing Engine. To use a laptop, modem, or other auxiliary
AUX
Turn off the power to the console or auxiliary device.
Press the tab on the connector and pull the connector straight out of the port.
Disconnect the cable from the console or auxiliary device.
Plug one end of the replacement Ethernet cable into the
Figure 52 on page 115 shows the external device ports on the Routing Engine.
Plug the female DB-9 end into the console or auxiliary device's serial port.
Removing an IOC on page 116
Installing an IOC on page 118
ETHERNET
port on the Routing Engine. Both ports accept a cable
port. Figure 52 on
or port.
CONSOLE AUX