Juniper SRX 5600 Hardware Manual page 72

SRX 5600 Services Gateway Hardware Guide
Unpacking the Services Gateway
The services gateway is shipped in a wooden crate. A wooden pallet forms the base
of the crate. The device chassis is bolted to this pallet. A Getting Started Guide and
a cardboard accessory box are also included in the shipping crate.
The shipping container measures 33.5 in. (85.1 cm) high, 28 in. (71.1 cm) wide, and
26 in. (66.0 cm) deep. The total weight of the container containing the device and
accessories can range from 153 lb (70 kg) to 351 lb (159.2 kg).
NOTE: The device is maximally protected inside the shipping crate. Do not unpack
it until you are ready to begin installation.
To unpack the device, follow these steps (see Figure 25 on page 47):
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
46
Unpacking the Services Gateway
Move the shipping crate to a staging area as close to the installation site as
possible, where you have enough room to remove the components from the
chassis. While the chassis is bolted to the pallet, you can use a forklift or pallet
jack to move it.
Position the shipping crate with the arrows pointing up.
Open all the latches on the shipping crate.
Remove the front door of the shipping crate cover and set it aside.
Slide the remainder of the shipping crate cover off the pallet.
Remove the foam covering the top of the device.
Remove the accessory box and the Getting Started Guide.
Verify the parts received against the lists in Table 23 on page 47 and Table 24
on page 48.
Remove the vapor corrosion inhibitor (VCI) packs attached to the pallet, being
careful not to break the VCI packs open.
To remove the brackets holding the chassis on the pallet, use a 1/2-in. socket
wrench and a number 2 Phillips screwdriver to remove the bolts and screws
from the brackets.
Store the brackets and bolts inside the accessory box.
Save the shipping crate cover, pallet, and packing materials in case you need to
move or ship the device at a later time.
To proceed with the installation, see "Installing the Services Gateway Using a
Lift" on page 54 or "Installing the Services Gateway Without a Mechanical Lift"
on page 201.