Chapter 8 Connecting The Services Gateway; Tools And Parts Required; Connecting The Services Gateway To Management And Alarm Devices - Juniper SRX 5600 Hardware Manual

Chapter 8
Connecting the Services Gateway

Tools and Parts Required

Connecting the Services Gateway to Management and Alarm Devices

This chapter discusses the following procedures:
Tools and Parts Required on page 57
Connecting the Services Gateway to Management and Alarm Devices on page 57
Connecting IOC Cables on page 60
To connect the device to management devices and to power on the device, you need
the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (-) screwdriver
2.5-mm Phillips (+) screwdriver
3/8-in. hexagonal-head external drive socket wrench, or nut driver, with a torque
range between 23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) tightening torque, for
tightening nuts to terminal studs on each power supply (on a DC-powered device)
CAUTION: Do not substitute a metric nut driver or wrench. A tool that does not fit
the nuts exactly can damage them. If a 3/8-in. tool is not available, use pliers or an
adjustable wrench.
Wire cutters
Pliers
Electrostatic discharge (ESD) grounding wrist strap
After you have installed the services gateway into the rack, attach one or more
external devices to the ports on the craft interface that connect to the Routing Engines
for management and service operations (see Figure 30 on page 58). For specifications
for the cable accepted by the Routing Engine management ports, see "Routing Engine
Interface Cable and Wire Specifications" on page 200.
Tools and Parts Required
57