Replacing The Craft Interface; Removing The Craft Interface; Installing The Craft Interface; Replacing Alarm Relay Wires - Juniper SRX 5600 Hardware Manual
Services gateway
Hide thumbs
Also See for SRX 5600:
- Hardware manual (483 pages) ,
- Installation and initial configuration manual (205 pages) ,
- Manual (34 pages)
Table of Contents
Advertisement
Table 27: Tools and Parts Required (continued)
Replacing the Craft Interface
The craft interface is located above the card cage, as shown in Figure 1 on page 6.
It houses the alarm relay interface ports and indicates status of services gateway
components.
The craft interface is hot-insertable and hot-removable. It weighs approximately
1.1 lb (0.50 kg). When you install the craft interface, allow several minutes for the
display to reflect the current state of the device.
To replace the craft interface, use the following procedures:
Tool or part
Electrostatic discharge (ESD)
grounding wrist strap
Flat-blade (–) screwdriver
Phillips (+) screwdrivers, numbers 1
and 2
Rubber safety cap
Wire cutters
Removing the Craft Interface on page 102
Installing the Craft Interface on page 102
Replacing Alarm Relay Wires on page 103
Chapter 13: Replacing Hardware Components
Components
All
Cables and connectors
IOC
Air filter
Routing Engine
Craft interface
SCB
Cables and connectors
Fan tray
IOC
SPC
SFP and XFP Transcievers
Cables and connectors
DC power supply
Replacing the Craft Interface
101
Advertisement
Table of Contents
Troubleshooting
