Figure 41: Removing The Craft Interface - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide
Removing the Craft Interface
To remove the craft interface (see Figure 41 on page 102):
1.
2.
3.
4.
5.

Figure 41: Removing the Craft Interface

Installing the Craft Interface
To install the craft interface (see Figure 42 on page 103):
1.
2.
3.
4.
102
Replacing the Craft Interface
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 152.
Detach any external devices connected to the craft interface.
Loosen the captive screws at the top left and right corners of the craft interface
faceplate.
Grasp the craft interface faceplate and carefully tilt it toward you until it is
horizontal.
Disconnect the ribbon cable from the back of the faceplate by gently pressing
on both sides of the latch with your thumb and forefinger. Remove the craft
interface from the chassis.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 152.
Grasp the craft interface with one hand and hold the bottom edge of the craft
interface with the other hand to support its weight.
Orient the ribbon cable so that it plugs into the connector socket. The connector
is keyed and can be inserted only one way.
Align the bottom of the craft interface with the sheet metal above the card cage
and press it into place.