Grounding And Providing Power To The Services Gateway; Tools And Parts Required; Grounding The Services Gateway - Juniper SRX 5600 Hardware Manual

Chapter 9
Grounding and Providing Power to the
Services Gateway

Tools and Parts Required

Tools and Parts Required on page 63
Grounding the Services Gateway on page 64
Connecting Power to an AC-Powered Services Gateway on page 64
Powering On an AC-Powered Services Gateway on page 65
Connecting Power to a DC-Powered Services Gateway on page 66
Powering On a DC-Powered Services Gateway on page 68
Powering Off the Services Gateway on page 70
To ground and provide power to the device, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (-) screwdriver
3/8-in. hexagonal-head external drive socket wrench, or nut driver, with a torque
range between 23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) tightening torque, for
tightening nuts to terminal studs on each power supply (on a DC-powered device)
CAUTION: Do not substitute a metric nut driver or wrench. A tool that does not fit
the nuts exactly can damage them. If a 3/8-in. tool is not available, use pliers or an
adjustable wrench.
Wire cutters
Electrostatic discharge (ESD) grounding wrist strap
Tools and Parts Required
63