Table 4: 4-Port 10-Gigabit Ethernet Ioc Leds; Table 5: 40-Port Gigabit Ethernet Ioc Leds - Juniper SRX 5600 Hardware Manual

SRX 5600 Services Gateway Hardware Guide
Table 4: 4-port 10 Gigabit Ethernet IOC LEDs

Table 5: 40-port Gigabit Ethernet IOC LEDs

Two LEDs, located on the craft interface above the IOC, display the status of the IOC
and are labeled
craft interface, see "IOC and SPC LEDs" on page 26.
10
I/O Cards
Two interfaces from the SCBs that enable the boards to be powered on and
controlled.
Physical IOC connectors.
Packet Forwarding Engines.
Midplane connectors and power circuitry.
Processor subsystem, which includes a 1.2-GHz CPU, system controller, and
1 GB of SDRAM.
LEDs on the 4–port 10–Gigabit Ethernet faceplate indicate the port status. LEDs
are labeled top to bottom
LEDs on the 40–port Gigabit Ethernet faceplate indicate the port status. LEDs
are labeled horizontally and left to right
through 2/5 , and 3/0 through
Label Color State
Green On steadily
OK/FAIL
Red On steadily
Green Off
TUNNEL
On steadily
Green On steadily
LINK
Off
Label Color State
Green On steadily
OK/FAIL
Red On steadily
Green On steadily
LINK
Off
and
OK FAIL
0/0 through 0/3 (see Table 4 on page 10).
through
0/0
3/5 (see Table 5 on page 10).
Description
IOC is functioning normally.
IOC has failed.
Normal operating mode.
Port configured in tunnel mode.
Link is active.
No link.
Description
IOC is functioning normally.
IOC has failed.
Link is active.
No link.
. For more information on the IOC LEDs located on the
, through ,
0/5 1/0 1/5 2/0